Dodge Caliber Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I Pulled batterie for 2 weeks switched altenator then put in a new batterie. Now I have power but it won't attempt to start, it did make an attempt before this. I ran for codes. U1403 came up but would that stop is from starting. Won't even click or turn over and I pulled the negative cabel a few times.
 

·
Registered
Joined
·
153 Posts
Are you sure you have enough battery power? Alternator was hooked up correctly? Battery terminals clean and tight?

Have you tried jump starting it?
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Are you sure you have enough battery power? Alternator was hooked up correctly? Battery terminals clean and tight?

Have you tried jump starting it?
It was 12.89vnow it is 12.54v Bought it new yesterday i haven't tried jumping it. I'll go back and reclean the negative and positive cabels tonight. Altenator has a red wire and a lockable wire harness that are both on perfectly
 
1 - 3 of 3 Posts
Top