Dodge Caliber Forum banner

replaced TIPM, now blower motor doesn't work

3K views 7 replies 3 participants last post by  longtimecoug 
#1 ·
h have gone awayI replaced my tipm on the 2009 caliber, it was creating all kinds of problems which have gone away since replacement. now the blower doesn't blow at all, I replaced it and still nothing. it appears that there is no power at the blower resistor. resetting tipm didn't solve the problem. now what sho0uld I look for? the tipm was a used one.
 
#2 ·
Stupid question, but did you look for a blown fuse? If fuse is okay, then unplug the harness on the blower motor and check it to see if you're getting power to it. Do that and report back.
 
#7 ·
Hope it was very cheap. Other than smashes junked Calibers will have fried TIPMs or seized CVTs.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top